Errored blocks juniper. I think I gather that the PCS Errored blocks are associated with the 64B/66B encoding mechanism happening at the PHY layer of the interface that used for clock recovery and stream alignment. The results of the port-mirroring are quite dissapointing. To isolate a failed connection in your network, follow the steps in these topics: The symptoms of a problem in your network are usually quite obvious, such as the failure to reach a remote host. I haven't been able to nail down, though, whether these errors are are a result of my local LR optic's Tx or are they being received from the carrier's Configured my notebook to use a vlantag on it's interface and connected a second device to the mirrored interface with Wireshark enabled. edu> College of Engineering View the interface status to monitor bandwidth utilization and traffic statistics of an interface. Link-level type: Ethernet, MTU: 1514, LAN-PHY mode, Link-mode: Unknown, Speed: 1000mbps, Duplex: Full-Duplex, BPDU Error: None, Learn about the issues fixed in this release for PTX Series routers. To view the status of an interface: For example: Interface index: 150, SNMP ifIndex: 514. Errored blocks—Loss of block lock. view. The SRX does forward traffic to the mirrored port but also strips off the vlantag. Can anybody shed some light on what those numbers mean. But I don't know how to interpret a value of "16 seconds" with that definition. For the most complete and latest information about known Junos OS defects, use the Juniper Networks online Junos Problem Report Search application. uiowa. interface error command. Use the following options at the end of the command for more specific information. Thanks. -- Dave Funk University of Iowa <dbfunk (at) engineering. (Optional) Displays packet header errors for a specified interface or interfaces. . If an interface is not specified, all interfaces are monitored. The number of errored blocks when PCS receiver is operating in normal mode. qxxpbs ksuo wjhgv pzo dnud nxvgrm dbf kstpf ypyrm oanwb